ZETRON 360 Bedienerhandbuch PDF herunterladen (Seite 42)

Programming

42 025-9459E

 USB-to-Serial port setup for Windows XP:

1. Install your USB-to-Serial convertor in the USB port in which you intend to use

it.

2. Open the Start menu and right-click on the My Computer link. Select the

Properties option from the pop-up menu that opens.

3. In the System Properties dialog that opens, click on the Hardware tab, and then

click on the Device Manager button that appears at the top of the Hardware tab.

4. The Found New Hardware wizard should open and ask to install new drivers for

the new hardware. Place the driver disk that came with the USB-to-Serial

convertor into the computer’s optical drive.

5. In the Device Manager dialog box, expand the Ports (COM & LPT) item in the

tree. Find the USB device that needs to have drivers installed, right-click on that

device and then select the Update drivers option from the pop-up menu that

opens.

6. Point the wizard to the optical drive to look for drivers and select Next. If a

Warning window opens, select the option to continue with the installation

anyway.

7. When the drivers have finished installing, return to the Device Manager dialog

box and expand the Ports (COM & LPT) item in the tree. Find the USB-to-

Serial COM port entry and right-click on it. Select Properties from the pop-up

menu. On the Properties page, locate the serial port settings and configure them

as follows:

bits per second: 9600

data bits: 8

parity: None

stop bits: 1

flow control: None

8. Click on the Advanced button at the bottom of the list of Port Settings. In the

Advanced Settings dialog that opens, use the COM Port Number: list box at the

bottom of the dialog to assign the USB port the convertor is plugged into as

either COM1 or COM2. Click the OK button in the Advanced Settings dialog

and then the OK button in the Port Properties window. When finished, close all

of the dialog boxes back out to the desktop.

In some cases, there may be conditions that force your hand and require that the Dosbox

configuration file be placed in some other location or that the serial port be pointed at

some other port than COM1 or COM2. For tips on how to handle these situations see

Editing the M360KA.conf File on page 45.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 76 77

Keine Kommentare

ZETRON 360 Bedienerhandbuch Seite 42